Products

Type A

Ultrasonic atomizer transducer is a piezoelectric wafer widely usedfor ultrasonic humidifier, medical nebulizer and many other atomizers. Type Aatomizer transducer is the transducer wafer with wires and rubber ring which iswidely used for humidifiers and nebulizers.

Siansonic uses the patented electrode coating technology for theatomizer transducers to obtain a very long lifetime and highly stableperformance. The transducers with nickel coating or titanium alloys coating cancontinuously operate with good performance for more than 10000 hours at normalcondition.  


  • Long lifetime: > 10000 hours

  • Tiny fog particle (diameter 1 - 6 µm).

  • High stable electrode coatings: nickel, titanium alloys and anti-corrosive coating

  • Wafer Diameter: 20mm, 25mm, 30mm

  • Frequency: 1.7MHz, 2.0MHz, 2.4MHz, 2.5MHz

  • Electrode Coating: Nickel, Titanium Alloys, Anti-corrosive

  • Cable Connector

  • The transducers (except the anti-corrosion model: coating E) should work in drinking water or similar liquids. If liquids have an acidity of less than pH5, it could makethe output performance decay,even permanently destroy the transducer. Therefore, the transducers cannotwork in the liquid that is excessively acidic (pH<5).<>

  • Provide a protective “low water” shut-off circuit. The transducers should NEVERworkwithout liquid in contact with them even though in a very short time (a few seconds).

  • Design a circuit to assure no voltage difference appears between surface of transducer and water. We highly recommend the float switch for liquid level control. PLEASE DON’TUSEELECTRODECONTROL FOR “NO WATER” PROTECTION! OTHERWISE THE TRANSDUCER COATING CAN BE ELECTROLYSED OUT.

  • The surface of transducers should be cleaned at times. It will NOT be considered as the quality problem on transducers, if the atomizing effect of transducers decays due to substances contained in liquid such as Ca, Na, Mg and Si etc. adhering to the transducers surface.